Home

href="
F145-1082  
Replacement Door for 1F90 & 1F97  
Comfort-Set II Digital Thermostats  
WHITE-RODGERS  
INSTALLATION INSTRUCTIONS  
Before installing the new door onto your digital thermo-  
stat, you will need to attach one of the two operating  
instruction labels to the new door.  
HOLD  
COPY  
1. Determine the type of thermostat you have. If the two  
buttons on the far right of the thermostat look like  
fig.1, you will use the label numbered 153-2324 (for  
the 1F97).  
RUN  
PRGM  
If the two buttons on the far right of your thermostat  
look like fig.2, you will use the label numbered 153-  
2325 (for the 1F90).  
Figure 1  
2. Placethethermostatdooronatableandpositionitso  
that the recessed area is facing up, and the door is  
positioned as shown in fig. 3.  
HOLD  
TEMP  
3. Peel the backing off the label you will use. Working  
from the upper edge, lay the label in place on the  
door. Gently wipe the label down to remove any air  
bubbles.  
ADV  
PRGM  
4. To install the door, insert the extruded dimples into  
therecesseslocatedonthelowerrightandleftedges  
of the thermostat (it may be necessary to bend the  
door slightly to fit it into place).  
Figure 2  
Recess  
Extruded  
Dimple  
Figure 3. Install door  
WHITE-RODGERS DIVISION  
EMERSON ELECTRIC CO.  
9797 REAVIS ROAD  
PART NO. 37-4466B  
Printed in U.S.A.  
Replaces 37-4466A  
9824  
ST. LOUIS, MISSOURI 63123-5398